Attention; the crew at quadrocopter.us has discovered that using a higher current recom regulator on the FC to supply 6.5 volts to the servos on the pro-mount
(AV200) vastly improves the responsiveness and smoothness of operation of the photohigher mounts. These regulators can be obtained from..

http://search.digikey.com/scripts/DkSearch/dksus.dll?lang=en&site=US&WT.z_homepage_link=hp_go_button&KeyWords=945-1055-ND&x=0&y=0
or from http://nl.farnell.com/jsp/search/productdetail.jsp?sku=1696321 - in Europe
For MK: Connect the roll and tilt servo's as shown - the top of the image = the front.
Open the Kopter Tool and minimise the values for the camera...do not have your
camera in the gimbal for this process. Then calibrate the MK to activate the FC.

If the roll and tilt are are not level or centered - follow the instructions below.

Roll - slightly loosen the 12.7mm nut securing the potentiometer - so that you can
turn the pot by hand (blue drum) - use the supplied droidworx mutli-tool - Place
your craft on a level surface and turn the pot until the roll cradle is level.

Adjust the settings for the desired response and roll rate and then tighten the nut.

Tilt - slightly loosen the 2mm Hex screw securing the potentiometer - so that you can
turn the pot by hand. Place your craft on a level surface and turn the pot until the
tilt tray and servo are centered and level.

Adjust the settings for the desired response and tilt rate and then tighten the screw.