SkyJib complete instruction manual download - note this is a 6 MB indexed PDF- right click and "save as"
Last Updated: 21/12/11 15:35 (NZDT)
Change Log
19/01/2012: Update to LG and CP attachment
21/12/2011: Crash Cage Assemblies Updated
14/12/2011: Modification to the center plate and landing gear attachement
CX complete instruction manual download - note this is a 3 MB indexed PDF - right click and "save as"
Last Updated: 15/12/11 09:42 (NZDT)
Change Log
30/01/2012: New landing gear assembly and minor tweaks
19/01/2012: Update to LG mounting spacers
15/12/2011: Landing gear attachment screw changed
14/12/2011: Added engine mount boot instructions
AD Series complete instruction manual download - note this is a 5 MB indexed PDF - right click and "save as"
Last Updated: 14/12/11 09:42 (NZDT)
14/12/2011:Added engine mount boot instructions
Tip for attaching the Boom Nacelle's to your craft.
Last Updated: 29/11/11 10:55 (NZDT)
Heavy lift coaxial engine mount assembly instructions here.
Note; standard coaxial mounting is the same however with the smaller lighter components supplied.
Applying the droidworx vinyl lettering and decals requires some precise steps; firstly the area where you wish to apply to decals
must be clean and free of dust and oil. Clean the area with a damp cloth and warm soapy water and then dry with a clean dry
cloth and leave for a few minutes. Then peel the back off the vinyl letter or decal and align the sticker into position and apply
rubbing any air out while pressing down. Leave the sticker in place for 5 minutes and then lift one end of the top sheet on
the sticker and peel back slowly rolling the top covering back and flat along the surface - try not to lift this top sheet vertically
but rather pull it back horizontally. If the area was clean the letters will not lift away with this top sheet. These are UV
stable high quality vinyl decals and will last for many years.
See images here
board faces the front of the craft square on - mount the hoverfly board on standoffs through the four remaining corner holes.
Go to: http://www.hoverflytech.com/Products.html for details on the hoverfly electronics.
the servo's can be connected to the bottom pins as shown in the link - SV2 tilt=nick and SV3 roll=roll. The MK FC ME 2.0 will require
a recom regulator fitted to the FC first - install a higher 6.5 volt regultor for the photohigher gimbals....see link below for details:
please read the data sheet before installing this regulator, incorrect installation may damage the MK FC.
available in the USA from Digikey : and in Europe from Farnell
To center the roll and tilt simply connect the servo's, callibrate the craft so the FC is active and then manually turn each
potentiometer till the roll cradle and tilt tray are centred...then tighten the fixing screw for the tilt potentiometer and the 12.7mm
nut on the roll potentiometer. Settings adjusted in the Kopter tool as required - it is best to reduce the setting values to a
minumin and then increase until the optimum values are found. Make sure you have installed the latest firmware for the MK.
See instruction images here
